Test and Measurement Forum

PT100 cable

Which product is right for your exact requirements

PT100 cable

Postby Marion » Tue Nov 26, 2002 5:00 pm

I am interested in the temperature measurement with the PT100 element (SE012) and the PT-104 Data Logger. But in oder to use it in my application I need to install a electrical feed-through connector in the PT100 cable. My question is therefore:
Can I cut the 2m cable of the PT100 and put a plug inbetween without loosing accuracy in the measurements? Or even shorten or lengthen the cable?
Thanks.
Marion
 

Extending PT100 cables

Postby matthew » Thu Nov 28, 2002 2:47 pm

Sorry it took a while to get back to you on this Marion, I needed to discuss some safety aspects with one of our electrical engineers.

The extension itself is no problem, our PT100s are 4 wire and hence are compensated for changes in cable resistances. The question arises that you may be using the PT100 probe in an 'intrinsically safe' environment (feed through connectors are sometimes used to isolate environmental chambers).

If you are using an 'intrinsically safe' environment, bear in mind that our products are not designed for this, which could pose a safety risk.

I hope this information helps you in your application.

Best Regards,
Matt Everett

Pico Software Engineer
User avatar
matthew
Guru
Guru
 
Posts: 109
Joined: Wed Sep 25, 2002 9:35 am
Location: Cambridgeshire, UK


Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 0 guests