Test and Measurement Forum

ADC16 Trigger setup

Post any questions about our serial port products

ADC16 Trigger setup

Postby tmcdonagh » Tue Nov 11, 2003 6:48 pm

I would like to set up a trigger event with my ADC16 to collect data for a specified period of time. After the collection period, I would like for the unit to recycle, increment the filename, and wait for another trigger event before collecting data. Is it possible to use the ADC16 to accept a trigger event such as a contact closure?



Postby markspencer » Wed Nov 12, 2003 11:40 am


The ADC-16, is not capable of using triggers as its sample rate is only 1.5Hz, therefore it cannot be used in 'Fast Block' mode which is required for the trigger to be set.

Best regards,

Mark Spencer
User avatar
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Return to Serial Port Products

Who is online

Users browsing this forum: No registered users and 0 guests