I'm developing a LabView program with a Picoscope 4224.
- the program starts with a call to 'ps4000OpenUnit'
- then it executes configurations and acquisitions
- the program ends with a call to 'ps4000CloseUnit'
Everything works OK but:
If I restart the VI without closing LabView I get an error from 'ps4000OpenUnit' (PICO_STATUS = 3).
If I close Labview, its window closes but its icon stays in the application tray for about 30 seconds.
The same happens if I run and then close the Application.exe made by the builder.
It can be a problem because sometime this application needs to be restarted after a few seconds.