Test and Measurement Forum

PicoLog fails to restart with ADC plugged in

Forum for discussing PicoLog

PicoLog fails to restart with ADC plugged in

Postby MTW » Fri Feb 05, 2010 12:26 pm

Hi! I'm using ADC-11/10 (USB) with latest PicoLog software (5.20.9). Operating system Windows 7 (fresh install and up to date). When I launch PicoLog for the first time everything is ok. When I then close PicoLog and try to restart it fails to connect with device and freezes! Sometimes the process is still visible in the task manager and sometimes it is not. Either way... until I unplug the ADC and plug back in ... it will not work! This could be very annoying... Thank you for any suggestions.
MTW
 

Re: PicoLog fails to restart with ADC plugged in

Postby Pico Stuart » Wed May 12, 2010 9:49 am

Dear MTW,

Thankyou for your inquiry with regard ADC11/10 and PicoLog application in Win 7.

Please could you proceed to the following link and download the latest version of PicoLog R5.21.1

http://www.picotech.com/software.html

Please note: parallel port products and the USB ADC-11 do not support 64-bit operation.

If you encounter nay difficulties please do not hesitate to contact me via support@picotech.com

Kindest regards,

Stuart
Technical Specialist
Pico Stuart
Site Admin
Site Admin
 
Posts: 72
Joined: Tue Jun 30, 2009 3:08 pm


Return to PicoLog

Who is online

Users browsing this forum: No registered users and 0 guests