Test and Measurement Forum

Dr.Daq - Electrical Conductivity

Post any questions about our parallel port products

Dr.Daq - Electrical Conductivity

Postby JohnBM » Mon Oct 27, 2003 8:40 pm

Does anyone know if it is possible to use Dr.Daq to log the electrical conductivity of a solution?

Thanks

JohnBM
JohnBM
 

Postby markspencer » Tue Oct 28, 2003 8:28 am

Hi,

The DRDAQ has a voltage channel. which can measure 0-5 volts with a 10 bit resolution. It would possible to measure electrical conductivity of a solution, however you would need to source a sensor and signal condition the output. A couple of distributors that may be able to help you are as follows:

www.rswww.com
www.farnell.com

Best regards,
Regards,

Mark Spencer
User avatar
markspencer
Site Admin
Site Admin
 
Posts: 598
Joined: Wed May 07, 2003 9:45 am


Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests