Test and Measurement Forum

how to get the reading from the unit itself?

Post any questions you may have about our current range of USB data loggers

how to get the reading from the unit itself?

Postby Ray » Thu Dec 24, 2009 12:35 am

How do I get my voltage, current and temperature reading once i install the picolog recorder software and plug in the data logger 1012 to a small terminal board PR112 and which hole must I connect it to at the small terminal board PR112 to get my reading?
Ray
 

Re: how to get the reading from the unit itself?

Postby PeterF » Sun Dec 27, 2009 6:03 pm

Hi,
The full answer to your question would be far longer than it is sensible to put in an email. I attach links to the PicoLog 1012 manual:-
http://www.picotech.com/document/pdf/pl1000-en.pdf
PicoLog program manual:-
http://www.picotech.com/document/pdf/plw044.pdf
Small terminal board manual:-
http://www.picotech.com/document/pdf/Sm ... sGuide.pdf
If you cannot get going using them, please contact via email at the help-desk:-
support@picotech.com
or by phone:- 01480-396395
on or after 4th January when the factory is again open.
Regards,
PeterF.
PeterF
Zen Master
Zen Master
 
Posts: 435
Joined: Thu Jun 07, 2007 10:53 am
Location: Cambridgeshire

Re: how to get the reading from the unit itself?

Postby Ray » Mon Dec 28, 2009 6:47 am

Thank alot for the help admin.. really appreciate alot =)
Ray
 


Return to USB PC Data Loggers

Who is online

Users browsing this forum: No registered users and 0 guests