ADC-20 input board

Post any questions you may have about our current range of USB data loggers
Post Reply
Mille
User
User
Posts: 4
Joined: Tue Apr 15, 2008 10:07 am

ADC-20 input board

Post by Mille »

Hello,

I'm using a ADC-20 datalogger.
Is it possible to measure voltage higher than 2.5V via a special input board?

Thank you for your answer,

Francois

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: ADC-20 input board

Post by ziko »

Hi yes you can purchase the terminal boar this allows you to solder some resistors to create a potential divider:

http://www.picotech.com/precision-data-acquisition.html
(scroll down a little and you will see it on the right hand side)

In the software you can then use choose a scaling file, lookup table or Equation to adjust your values.

There is a user guide for the terminal board:

http://www.picotech.com/document/pdf/ad ... _guide.pdf

Hope this helps.

Kind regards
Ziko

Technical Specialist

Post Reply