Problem with saving CVS data to file

Post any questions you may have about our current range of oscilloscopes
Post Reply
PAK

Problem with saving CVS data to file

Post by PAK » Mon Nov 02, 2009 4:19 pm

Hi,
I recently purchased a 4000

I'm trying get a trace of voltage measurements on CH_A and CH_B as well as plotting and A-B reading. The problem is that when i try to save the output of a trace to file all the readings saved are the same for each channel - which is definately not what the plot shows.

Also, if i try to "save All waveforms" as CVS files then i end up with multiple files with all with different readings.

It really doesn't make any sense. Can you please tell me what's is going on?

PAK
Newbie
Posts: 0
Joined: Mon Nov 02, 2009 5:34 pm

Re: Problem with saving CVS data to file

Post by PAK » Mon Nov 02, 2009 6:03 pm

Having spent a bit more time looking at this I think the only problem is that you have a bug with “Save current waveform” where only CH_B readings are dumped to the CSV file as both CH_A and CH_B readings.

gruntman
Advanced User
Advanced User
Posts: 109
Joined: Thu Sep 28, 2006 3:50 pm

Re: Problem with saving CVS data to file

Post by gruntman » Tue Nov 03, 2009 8:29 pm

PAK,

What software version are you using? Try out R6.3.4 which you can download from http://labs.picotech.com/ and see if this fixes your save as CSV issues...

Regards,

Richard Boyd
Crag Technologies, Inc
http://www.pc-oscilloscopes.com

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: Problem with saving CVS data to file

Post by ziko » Thu Nov 05, 2009 10:35 am

Hi this is a known problem and has been fixed in the beta software 6.3.4 as Richard mentioned, this is however a beta software but should stand you in good stead until we have a full release.

Kind regards
Ziko

Technical Specialist

Post Reply