Signal generator trigger (2203)

Post any questions you may have about our current range of oscilloscopes
Post Reply
Posts: 1
Joined: Sun Oct 04, 2009 4:34 pm

Signal generator trigger (2203)

Post by Speedy » Sun Oct 04, 2009 4:51 pm

Dear Sirs,

my scope is the 2203 model with two acquisition input channels and a signal generator output (with AWG).

I would to know if I can trigger the signal generator start trough the oscilloscope trigger. In other words, I would syncronize signal generator start with data acquisition trigger (or with input channel event).

If waht described is not possible using default software, can I write a dedicated routine ?


Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko » Mon Oct 05, 2009 4:33 pm

Hi and thank you for your post.

You cannot achieve this with our software, however if you were to write your own software you should be able to do this. If you go to our software download page, you can find some simple programming examples available and the technical reference manual detailing all the function calls.

Kind regards

Technical Specialist

Post Reply