Test and Measurement Forum

Position Adjust

Post any questions you may have about our current range of oscilloscopes

Position Adjust

Postby bartj » Wed Jun 10, 2009 4:52 am

In looking over the programmers manual it appears that there is no way to adjust the vertical offset (position) of a signal. Presently we use low end tek scopes and am able to adjust vertical offset to allow optimal dynamic range when making measurements on bi-phasic waveforms.

Can I assume that the 2200 series does not allow for programmable offset control?

Thanks,
bartj
bartj
User
User
 
Posts: 2
Joined: Wed Sep 20, 2006 11:59 pm

Postby Robin » Wed Jun 10, 2009 8:01 am

That's correct. The voltage ranges that can be selected are the ones shown below. You select the voltage range when you call ps2000_set_channel

±50 mV
±100 mV
±200 mV
±500 mV
±1 V
±2 V
±5 V
±10 V
±20 V

Robin
Robin
Zen Master
Zen Master
 
Posts: 558
Joined: Fri Sep 19, 2008 10:17 am


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 1 guest