Test and Measurement Forum

adc-212 single shot trigger

Post any questions about our parallel port products

adc-212 single shot trigger

Postby wozencroftm » Thu May 21, 2009 1:32 pm

I am trying to capture a single shot sine wave superimposed on 2.5V dc
The sine wave has a period of 0.6sec and a peak value of 1.7V.
If I set trigger threshold to 3V.
Triggers ok with time-base of 100ms. If I increase timebase to get a better display signal just scrolls on left.
Posts: 1
Joined: Wed May 13, 2009 9:58 am

Postby Robin » Thu May 28, 2009 10:52 am


Go to settings->options->advanced. You can then change the slow sampling mode to either block or standard. In block mode, the whole waveform will be collected before being displayed.

I hope this helps

Advanced User
Advanced User
Posts: 558
Joined: Fri Sep 19, 2008 10:17 am

Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 1 guest