Test and Measurement Forum

Logging pulses with a ADC11

Which product is right for your exact requirements

Logging pulses with a ADC11

Postby Guest » Wed Feb 11, 2009 1:15 am

I want to log and totalise 100ms pulses every quarter of an hour.

The pulses are from an electricity meter and are on average about 1 per sec.

Can I use my ADC11 and Picolog software to do this? Can't see an obvious way
Guest
 

Postby ziko » Wed Feb 11, 2009 9:30 am

Hi using PicoLog, you can get the unit to repeat recording after a delay or immediately. If you use the device in fast block mode you can then get it to start recording on a trigger event.

Let me know if you require further info.

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to Pre-Sales Advice

Who is online

Users browsing this forum: Bing [Bot] and 1 guest