Test and Measurement Forum

Picoscope 4224 Oscilloscope

Which product is right for your exact requirements

Picoscope 4224 Oscilloscope

Postby Guest » Tue Feb 10, 2009 9:23 am

Hi Sirs,

I'm thinking to buy the Picoscope 4224 Oscilloscope.

I'm comparing the 4224 data sheet with the 3204 and I have some questions:

- what is the Spectrum range frequency of the 4224 ?

- the 4224 have 80 MS/s Sampling rate but I suppose that is single shot.
What is the sampling rate ripetitive ?

- with the 4224 there is the XY mode ?

Thanks and regards
Bruno
Guest
 

Postby ziko » Tue Feb 10, 2009 10:56 am

There spectrum range of the 4000 using our software is 20MHz, the ranges available in our software are as follows:

100Hz, 200Hz, 500Hz, 1kHz, 2kHz, 5kHz, 10kHz, 20kHz, 50kHz, 100kHz, 200kHz, 500kHz, 1MHz, 2MHz, 5MHz, 10MHz, 20MHz

80MS/s is as you pointed out the single shot sample rate, when you say repetitive do you mean ETS? If so then the answer is, there is no ETS for the 4000. Or do you mean streaming? The device has no real limit in terms of streaming on some computers you can get 10MS/s and above. Using our software there is a limit to the streaming mode up 1MS/s.

There is another mode which is called rapid block mode, in this mode the device will sample in single shot mode, however the time delay between the next sample is much smaller than normal, it reduces the gap from milliseconds to about 2.5 microseconds.

Using our latest software you can use XY mode.

Hope this helps.
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Picoscope 4224 Oscilloscope

Postby Guest » Wed Feb 11, 2009 8:35 pm

OK, thanks for explanation.

Just bought the 4224 Oscilloscope at RS Components in Italy.

Regards
Bruno
Guest
 


Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 0 guests