usbadc11 digital output

Post your .Net discussions here
Post Reply
tobiashofer
User
User
Posts: 8
Joined: Thu Oct 09, 2008 7:33 am

usbadc11 digital output

Post by tobiashofer »

Hello

I'm writting a new windows software for the usb adc11 device. I'm using the usbadc11.dll .
Now i'm wondering how to set the digital output with this driver. Is it possible?

Many thanks in advance

tobias hofer

tobiashofer
User
User
Posts: 8
Joined: Thu Oct 09, 2008 7:33 am

Post by tobiashofer »

Hello Again

I managed to set the digtial outputs on the adc11/12. But now i have
a problem with collecting datas in block.

when i use the fucntion GetTimeAndValue(...) i always recieve only 40 samples.

does anybode know how to fix this problem?

best regards
tobias hofer

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi tobiashofer,

Have you tried to recreate this using PicoLog? If you still have the same problem then the unit might have a problem with the PC, which affects a small percentage of PCs.

Kind regards
Ziko

Technical Specialist

tobiashofer
User
User
Posts: 8
Joined: Thu Oct 09, 2008 7:33 am

Post by tobiashofer »

I tested the data logger with pico log and reading a block of data.

It also dosn't work with pico log!

>If you still have the same problem then the unit might have a problem with >the PC, which affects a small percentage of PCs.
Is there a new driver or bugg fix? The datalogger is for an automative testsystem and should work on every pc.

best regards

hofer tobias

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi tobiashofer,

I would try to install it on another computer and see if you encounter the same problems.

Kind regards
Ziko

Technical Specialist

Post Reply