I can't get any signal but +5VDC from my just-purchased ADC-12.
I have another computer with an ADC-10 and a VB program that works just fine.
I am using a physical parallel port on both machines, and both are running XP.
I purchased the ADC-12 to replicate the system (I could no longer get the ADC-10).
I have read through these forums and seen a number of issues that would appear similar to mine. However, there are not many user responses to the effect: "This is what fixed it for me.".
Using either PicoScope (5.20.1), the VB example from "adc10sdk_r1_0_0.zip", or my program that works with the older system (ADC-10, different PC) I only ever get +5VDC.
In the BIOS I have set LPT1 to the address 378, IRQ7 as suggested.
In the BIOS I have tried all the port modes available: output only, Bi-directional, ECP and EPP.
In PicoScope I have tried selecting LPT1 (gives +5VDC only), LPT2 and LPT3 these latter two produce an error dialog stating that the ADC-12 is not connected.
The VB example from "adc10sdk_r1_0_0.zip" (I changed product from 10 to 12 and the scaling divisor in adc_to_mv from 255 to 4095) returns:
ADC-12 on LPT1
Can you suggest anything else?
This is very frustrating and time consuming. The option of purchasing the pico USB-to-parallel coverter is not particulary appealling due the additional cost and that I am not confident it will solve my problem.
Additionally, I bought the ADC-12 after reading that it is supported under XP by PicoScope and the programming interface.
Having problems ? let us know the details here
2 posts • Page 1 of 1