Test and Measurement Forum

Unable to use triggers in v6.0.15

Forum for discussing PicoScope (version 5)

Unable to use triggers in v6.0.15

Postby tehpeh » Tue Jun 24, 2008 12:46 pm

Hi

I have recently upgraded from SW version 6.0.13 to 6.0.15 and since then I can't make the trigger work. I use single trigger with Repeat mode, but I can get only a "free running" graph. In the previous version it was all fine.

Furthermore, when I move the trigger point (yellow rhombus) on the screen, the trace on the screen moves as well. if I place the trigger one division from the the left side of the screen, the signal runs from left up to one position from the right.
When I move the trigger towards the centre, the trace seems to be shifted right.

I have tried to reset the User Preferences, but it did no change.

What am I doing wrong to make the trigger work?

Cheers
tehpeh
Newbie
 
Posts: 1
Joined: Tue Jun 24, 2008 12:43 pm

Postby Guest » Tue Jun 24, 2008 11:00 pm

trigger doesn't work in R6.0.15. see R6 forum it's already been answered by picotech.
Guest
 

Postby ziko » Wed Jun 25, 2008 11:15 am

Hi this is true the next release has this fixed, in the mean time could you un-install the current version and install 6.0.14 which can be found on

http://www.picotech.com/software-archive.html

Apologies for any inconvenience.

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to PicoScope 5

Who is online

Users browsing this forum: No registered users and 0 guests