Magnitude trigger on one channel with PWQ on another

Post any questions related to the new PicoScope 7 software
Post Reply
phgphd
Newbie
Posts: 0
Joined: Wed Jun 16, 2021 12:33 am

Magnitude trigger on one channel with PWQ on another

Post by phgphd »

Using a Picoscope 4424A and Picoscope 7 PS4000A API. If I set up a dual trigger situation with a magnitude trigger on channel D and a pulse width trigger on channel A, when does the pulse width counting begin? Does the pulse width counting begin when the channel D triggers or does the pulse width begin with a independent trigger level?

My gut understanding is that this is not possible with Picoscope. The Window and PWQ must be on the same channel.

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Magnitude trigger on one channel with PWQ on another

Post by Martyn »

The pulse width trigger would be setup to run on a particular channel, all timing would be related to this channel. This can be used in a logic trigger with a trigger event on another channel. so that both events meet the logic condition.

If this sounds like what you are looking for, but are unable to get it to work, then please email your code to support@picotech.com and one of the team can take a look for you.
Martyn
Technical Support Manager

Post Reply