I am using my 5000 series scope to do some logging of a PWM signal that vary in amplitude and duty cycle as well as the frequency from 30 Hz and down to 6 Hz
the signal has to be sampled every 1 ms
where i want to log the average, min and max value of the signal e.g over 10 sec
this seems to work by configure the data table and setting the output sample to 10 sec.
is there a way to get it to plot the min, max, and average instead of each sample taken at each msec ?
my measurements will be running for months so storing 1msec sample would create to much data
Forum for discussing PicoLog
1 post • Page 1 of 1