Is it possible to change the voltage range in picoscope?

edogawa1994 · Post by **edogawa1994** » Tue Feb 09, 2021 4:09 am

I am currently creating the interface program for picoscope with Labview. Based on the picoscope manual book, it says that I can create some voltage range by specifying some value from 3 to 10. I attached the table here as well. My question is if it possible to create a voltage range between 200 and 500 mV (like 300 mV)?
Because when I tried to access the function in labview, it led me to a dll files.

Thank you very much.

Post by **AndrewA** » Thu Feb 11, 2021 10:49 am

Hi,
We have LabVIEW software examples are available from our GitHub repositories see-
https://github.com/picotech/picosdk-ni-labview-examples
Note examples for 32-bit and 64-bit version of LabVIEW.
Follow the instructions here-
https://github.com/picotech/picosdk-ni- ... /README.md

Test & Measurement Forum

Is it possible to change the voltage range in picoscope?

Is it possible to change the voltage range in picoscope?

Re: Is it possible to change the voltage range in picoscope?