PicoScope 7 Software
Available on Windows, Mac and Linux
Question about "Window Puls width" trigger of 5244D MSO
Question about "Window Puls width" trigger of 5244D MSO
Hello Martyn!
I set a 1KHZ square wave signal in my 5244D MSO, and then select the “Window Puls width” trigger of the oscilloscope, set the voltage range, and set the “time” to be greater than 8 nanoseconds, but it cannot trigger......
1KHz square wave pulse width certainly larger than I set the time waveforms should be triggered.
Is my understanding of this trigger wrong?
Hope to get your help, thank you!
I set a 1KHZ square wave signal in my 5244D MSO, and then select the “Window Puls width” trigger of the oscilloscope, set the voltage range, and set the “time” to be greater than 8 nanoseconds, but it cannot trigger......
1KHz square wave pulse width certainly larger than I set the time waveforms should be triggered.
Is my understanding of this trigger wrong?
Hope to get your help, thank you!
- Attachments
-
-
- Window Puls width trigger.pssettings
- (3.45 KiB) Downloaded 241 times
-
- Window Puls width trigger.psdata
- (3.2 MiB) Downloaded 267 times
Re: Question about "Window Puls width" trigger of 5244D MSO
There may be an issue with Dwell Inside, if you change to Dwell Outside it works correctly. I will do some further investigation and then report to the development team.
Martyn
Technical Support Manager
Technical Support Manager
Re: Question about "Window Puls width" trigger of 5244D MSO
Yes, Martyn.
It looks like this is a problem with PicoScope 6.14.23, I updated to
Everything is normal after PicoScope 6.14.36!
But I have another question. Why can't the persistence mode and spectrum mode customize the sampling rate? And I found that their sampling rate is very low, so the screen display update speed is very slow.
In the spectrum mode, when I tried to test the X axis setting at 100Hz, it took at least 2 minutes to wait for the spectrum image to come out! That is, the "time gate" is very large. is this normal?
Thanks again!
Good luck!
