PicoScope 7 Software
Available on Windows, Mac and Linux
Different results using same signal with blok mode recording via MATLAB and via picoscope 6 software
Different results using same signal with blok mode recording via MATLAB and via picoscope 6 software
Hi.
I use Picoscope 5444D MSO and I ran into a problem with mismatched results when using block mode and Picoscope 6 software. I measured 500kHz ramp signal with 8 bit resolution and 125ms/s in single channel mode. First of all, I thought that errors arise from the bit rate or the sampling frequency. However, changing these two parameters in higher side did not work. If you have any ideas why this difference appear, let me know.
Kind regards
I use Picoscope 5444D MSO and I ran into a problem with mismatched results when using block mode and Picoscope 6 software. I measured 500kHz ramp signal with 8 bit resolution and 125ms/s in single channel mode. First of all, I thought that errors arise from the bit rate or the sampling frequency. However, changing these two parameters in higher side did not work. If you have any ideas why this difference appear, let me know.
Kind regards
- Attachments
-
- Picoscope.docx
- (338.19 KiB) Downloaded 345 times