Different results using same signal with blok mode recording via MATLAB and via picoscope 6 software

Having problems ? let us know the details here
Post Reply
den4952
Newbie
Posts: 1
Joined: Wed Oct 07, 2020 3:13 pm

Different results using same signal with blok mode recording via MATLAB and via picoscope 6 software

Post by den4952 »

Hi.

I use Picoscope 5444D MSO and I ran into a problem with mismatched results when using block mode and Picoscope 6 software. I measured 500kHz ramp signal with 8 bit resolution and 125ms/s in single channel mode. First of all, I thought that errors arise from the bit rate or the sampling frequency. However, changing these two parameters in higher side did not work. If you have any ideas why this difference appear, let me know.
Kind regards
Attachments
Picoscope.docx
(338.19 KiB) Downloaded 24 times

Post Reply