Time and Date Stamp Incorrect

woster · Post by **woster** » Wed Jan 13, 2021 12:54 pm

Good afternoon,

I'm looking for some advice with PICOLog and digital pressure sensors.
I have a 1216 with 8 channels monitoring pressure. I want the data time stamped and recording interval of 30 minutes. i have the sensors reading every 30 seconds, for the graph, but the table and datalogging is 30 minutes. I set the sample as "last" and not min, max or average. When i start the logging, the time stamp is recorded e.g. 12:39 but the values of pressure are not recorded for 30 minutes. therefore every reading is technically time stamped incorrectly, by 30 minutes. have i configured this wrong? or can i change this?

many thanks

Post by **Gerry** » Fri Jan 15, 2021 2:45 pm

Hi Woster,

Could you post your data file.

Regards,

Gerry

woster · Post by **woster** » Mon Jan 18, 2021 11:19 am

Hi Gerry,

Thanks for the reply.
I am currently unable to at the moment as the laptop has both USB taken. Will send over asap.

Thanks

woster · Post by **woster** » Wed Jan 20, 2021 11:48 am

Gerry wrote: ↑
Fri Jan 15, 2021 2:45 pm
Hi Woster,

Could you post your data file.

Regards,

Gerry

Hi Gerry,

Can i send the data over email?

Post by **Gerry** » Thu Jan 21, 2021 2:01 pm

Hi Woster,

Sure, you can send it to Support@picotech.com and mark it for my attention. This will create a support ticket in our system that I can then look at.

Regards,

Gerry

Test & Measurement Forum

Time and Date Stamp Incorrect

Time and Date Stamp Incorrect

Re: Time and Date Stamp Incorrect

Re: Time and Date Stamp Incorrect

Re: Time and Date Stamp Incorrect

Re: Time and Date Stamp Incorrect