PicoScope 7 Software
Available on Windows, Mac and Linux
3404D AWG single shot
3404D AWG single shot
I would like to generate a single shot of a waveform upon software trigger. How would I go about this? I have been able to start a continuous run, but have not been able to generate a single shot.
Re: 3404D AWG single shot
Hi
If you set the Cycles Per Trigger setting in PicoScope 6 (or the shots variable if using the PicoSDK) to 1 then on a trigger the scope will output a single cycle of the signal then stop at each trigger.
If you set the Cycles Per Trigger setting in PicoScope 6 (or the shots variable if using the PicoSDK) to 1 then on a trigger the scope will output a single cycle of the signal then stop at each trigger.
Neil
Technical Support Engineer
Technical Support Engineer