PicoScope 7 Software
Available on Windows, Mac and Linux
PicoScope 6403: maximum possible sampling rate
PicoScope 6403: maximum possible sampling rate
Hello everyone!
I have a question about the maximum possible sampling rate.
A PicoScope 6403 (Serial Number: AY166 / 046) with 1 GS buffer size is used.
I use 4 analog channels (8 bit resolution) and record a single curve over 20 s.
More than 10 MS / s cannot be set. With a recording time of 20 s and 4 channels, this corresponds to almost 1 GS. I can understand that.
The sampling time is displayed as 2 µs. I do not understand this, because 1 / (10MS / s) are 100 ns.
Or calculated differently: 20 s / 2 µs * 4 channels = buffer requirement of 40 MS.
Can anyone help me further?
Thanks a lot!
I have a question about the maximum possible sampling rate.
A PicoScope 6403 (Serial Number: AY166 / 046) with 1 GS buffer size is used.
I use 4 analog channels (8 bit resolution) and record a single curve over 20 s.
More than 10 MS / s cannot be set. With a recording time of 20 s and 4 channels, this corresponds to almost 1 GS. I can understand that.
The sampling time is displayed as 2 µs. I do not understand this, because 1 / (10MS / s) are 100 ns.
Or calculated differently: 20 s / 2 µs * 4 channels = buffer requirement of 40 MS.
Can anyone help me further?
Thanks a lot!
Re: PicoScope 6403: maximum possible sampling rate
Hi HPC,
Could you make sure that you have the Properties Pane displayed (by going to Views->View Properties) and then take a screenshot of your PicoScope 6 window, and post it here.
Regards,
Gerry
Could you make sure that you have the Properties Pane displayed (by going to Views->View Properties) and then take a screenshot of your PicoScope 6 window, and post it here.
Regards,
Gerry
Gerry
Technical Specialist
Technical Specialist