Setup the Pico 4262 signal generator to output: 1.228 VAC @ 400 Hz with the source (load) impedance of 150 ohms

Post any questions you may have about our current range of oscilloscopes
Post Reply
grievousangel
Newbie
Posts: 0
Joined: Wed Oct 02, 2019 8:57 am
Location: SE Georgia, USA

Setup the Pico 4262 signal generator to output: 1.228 VAC @ 400 Hz with the source (load) impedance of 150 ohms

Post by grievousangel » Sun Nov 10, 2019 11:56 pm

I need to setup the Pico 4262 signal generator to output: 1.228 VAC (+4dbu) @ 400 Hz with the source impedance of 150 ohms. Output appears to in 1V intervals unless below 1V, then 100 mV intervals.

Can I set 4262 signal gen to output dbu, say +4dbu? Is it possible to set a load impedance, say 150Z or 600Z?

If not in the current Version 6, can it be added in next release? Has anyone written code to do this? In the audio world, this would seem to be a popular need.

Cheers,

Billy
GrievousAngel
Picoscope 4262

Gerry
PICO STAFF
PICO STAFF
Posts: 504
Joined: Mon Aug 11, 2014 11:14 am

Re: Setup the Pico 4262 signal generator to output: 1.228 VAC @ 400 Hz with the source (load) impedance of 150 ohms

Post by Gerry » Mon Nov 11, 2019 10:34 am

Hi Billy,

Please review the answer on your previous post.

Regards,

Gerry
Gerry
Technical Specialist

Post Reply