Using trigger in 2204A Picoscope

Post any questions you may have about our current range of oscilloscopes
Post Reply
ninhphuc
Newbie
Posts: 0
Joined: Thu Jul 25, 2019 1:26 am

Using trigger in 2204A Picoscope

Post by ninhphuc » Thu Jul 25, 2019 2:23 am

Can I use advanced trigger as "Pulse Width trigger" for analog channel? Moreover, can it be used in "Auto" trigger mode? Because when I use in the Demo mode, combination of "Auto" trigger mode and "Pulse Width trigger" seems to be not correct. It captured the signal all the time even though the trigger did not occur.

Best regards,

Martyn
Site Admin
Site Admin
Posts: 3713
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Using trigger in 2204A Picoscope

Post by Martyn » Thu Jul 25, 2019 5:14 am

Trigger Modes
Auto: PicoScope waits for a trigger event before capturing data. If there is no trigger event within a reasonable time (~1 second on PicoScope 6), it captures data anyway. It repeats this process until you click the Stop button. Auto mode does not set the trigger level automatically.

Pulse Width Trigger can be used on analog channels
Martyn
Technical Support Manager

Post Reply