Picoscope6 Beta - 100 Hz Frequency Span not working

Discussion forum for the Picoscope 6 Linux software
Post Reply
dnessett
Active User
Active User
Posts: 39
Joined: Tue Oct 16, 2018 10:30 pm

Picoscope6 Beta - 100 Hz Frequency Span not working

Post by dnessett »

Hi,

I am trying to display the spectrum of a signal using a frequency span of 100 Hz. I select 100 Hz, use 1024 bins and press start. The properties panel shows a gate time of ~10 seconds. But, in fact nothing happens. I waited over a minute in case there was some sort of startup problem, but no luck.

I have successfully analyzed the spectrum of the input signal for frequency spans of 1 KHz, 10 KHz and 100 KHz, so I think the signal input is properly configured. I have attached an image that show the properties of the run.

Thanks,

Dan
Attachments
Frequency Span of 100 Hz not working (Compressed).png

dnessett
Active User
Active User
Posts: 39
Joined: Tue Oct 16, 2018 10:30 pm

Re: Picoscope6 Beta - 100 Hz Frequency Span not working

Post by dnessett »

Nevermind - operator error. Somehow I managed to set the trigger to "single". Sorry to bother everyone.

Dan

Added later (4-20-2019): Well it seems it wasn't "operator error" after all. See my subsequent post topic39791.html.

Post Reply