Measure DC-Values at "Ruler 1"

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
GW4BYK
Newbie
Posts: 0
Joined: Fri Feb 24, 2017 7:54 am

Measure DC-Values at "Ruler 1"

Post by GW4BYK »

Hi all,
I want to measure the DC-Values of all active traces at the time defined by a time-ruler. Can this be easily achieved? If so, how do I do this? I don't want to move all of my voltage-rulers to where the curves cross my time-ruler.

Kind regards,
Georg

AndrewA
PICO STAFF
PICO STAFF
Posts: 400
Joined: Tue Oct 21, 2014 3:07 pm

Re: Measure DC-Values at "Ruler 1"

Post by AndrewA »

Hi Georg,

Unfortunately there is no way to do this. You have manually line up all your voltage rulers for each channel with a time ruler.
Regards Andrew
Technical Specialist

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Measure DC-Values at "Ruler 1"

Post by Martyn »

It might take a little effort to set up but there is a workaround to get the values.

Enable a Measurement of Maximum for each channel you wish to see, and select between rulers for the measurement, then drag in the two time rulers and place them as close to each other as possible (manually entering values in the legend works) then lock the rulers with the legend padlock. Dragging the locked rulers will give you the measurements for all channels.
Martyn
Technical Support Manager

Post Reply