VNA Feature Request

Discussions forum for our Sampling Oscilloscopes, VNA, and Pulse Generators
Post Reply
Volker
Newbie
Posts: 0
Joined: Thu Feb 28, 2019 11:59 am

VNA Feature Request

Post by Volker »

It would be very nice to have an additional 3 tiled screen.
If you use 2 or 4 tiled screens and have a Smith Chart in one of them, the Smith chart
is very tiny. Espacially if you are doing 1 port measurements it would be nice to have
two logmag screens on the left and one bigger Smith chart in the middle. Due to the very common HD resolution of action monitors and the common aspect ratio the middle area would be perfectly square
for the Smith chart.

RF Mark
PICO STAFF
PICO STAFF
Posts: 0
Joined: Tue Apr 16, 2019 10:35 am

Re: VNA Feature Request

Post by RF Mark »

This is a good input, thank you. I have added a future development "story" to this effect. Unfortunately I cannot offer this solution in the immediate future but please be assured that your request has been captured. Apologies too that this did not get a response at an earlier date.

Volker
Newbie
Posts: 0
Joined: Thu Feb 28, 2019 11:59 am

Re: VNA Feature Request

Post by Volker »

Hi Mark,
it would also be nice to have two tiled screen with horizontal alignment of the two S-Parameter plots.
By now they are vertical alligned. I have attached a screenshot with two smith chart ( very small as mentioned before ) that shows the problem.
Attachments
50_1250MHz401.cal.jpg

Post Reply