I tried to connect MATLAB to picoscope and was able to run one of the examples. But I am getting an error message which is copied below.
Warning: Disconnect: No devices found.
Error using icdevice (line 313)
An error occurred while executing the driver create code.
No units found.
If the error is not an instrument error, use MIDEDIT to inspect
Error in PS5000A_ID_Block_2_Scope_Example (line 95)
ps5000aDeviceObj1 = icdevice('picotech_ps5000a_generic.mdd',
I tried reconnecting the picoscope many times but it didn't help. Can you please help me with the above problem?
Post your MATLAB discussions here
2 posts • Page 1 of 1