Test and Measurement Forum

PS5000 question - Getting timestamp from device

Post general discussions on using our drivers to write your own software here

PS5000 question - Getting timestamp from device

Postby Guest » Tue Apr 01, 2008 3:12 pm

Hi,

I'm in the process of writing a tool that will be used for logging input signals from a Picoscope 5000 over a very long period of time. The programming language is C++ and up to now the tool is mostly based on the provided example application (PS5000con.c). I'm using Streaming Mode (data shall be written to disk directly), aggregation is not used.

Now I need to assign each measured value to its measure time. Is there a way to get a timestamp for each measurement directly from the hardware? Operationg system's time functions are of course much too low in resolution. I would appreciate a small code sample if possible.

Thank you very much for helping me out
Guest
 

Postby picojohn » Wed Apr 02, 2008 10:37 am

Hello Guest,

It is not possible to derive that type of information from the PicoScope hardware.

Regards
John
picojohn
Zen Master
Zen Master
 
Posts: 382
Joined: Mon Jun 11, 2007 1:10 pm


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 1 guest