5244B with library?

Post any questions you may have about our current range of oscilloscopes
Post Reply
KAndreas
Newbie
Posts: 0
Joined: Thu Dec 06, 2018 8:43 am

5244B with library?

Post by KAndreas » Wed Dec 19, 2018 5:12 pm

Can i use the two channel oscilloscope 5244B with the library?
Just to be sure.

Andreas

Martyn
Site Admin
Site Admin
Posts: 3532
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: 5244B with library?

Post by Martyn » Thu Dec 20, 2018 8:13 am

Yes you can.
Martyn
Technical Support Manager

KAndreas
Newbie
Posts: 0
Joined: Thu Dec 06, 2018 8:43 am

Re: 5244B with library?

Post by KAndreas » Thu Dec 20, 2018 8:22 am

One more question, at the download page i can not find the link to the SDK for the Picoscope 5244D.
Can i user the SDK nevertheless for the 5224D.

I have seen the 5224B is obsolete.

I wan't to measure the raise time of partial discharge impulses. The raise time of this impulses is < 10ns.
In the datasheet of 5244B you meantion a smallest measurable impuls width of 5ns? Could you specify this a little bit more? Can i measure a impulse width of 6,95 ns or will i only see 5ns or 10ns?

Martyn
Site Admin
Site Admin
Posts: 3532
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: 5244B with library?

Post by Martyn » Thu Dec 20, 2018 8:54 am

We have an SDK for the 5000D models although this is currently not available on the website, so please contact support@picotech.com if you require this.

Minimum detectable pulse width 5 ns - this refers to the digital channels on the 5000D MSO models and is not relevant to analog channels.

The rise times for the B and D models are the same
5.8nsecs for 60MHz models
3.5nsecs for 100MHz models (except 16bit mode then 5.8nsec)
1.75nsecs for 200MHz models (except 16bit mode then 5.8nsec)
Martyn
Technical Support Manager

Post Reply