Measuring waveforms of 20Khz Inverter based welders and UPS

Which product is right for your exact requirements
Post Reply
Guest

Measuring waveforms of 20Khz Inverter based welders and UPS

Post by Guest » Wed Mar 26, 2008 3:05 pm

Can these PC based scopes be used for measuring waveforms under load conditions of 3 phase 415V Inverter based welders using 100/150 or 200A IGBT's? And at the secondary Diode (upto 400A and 30~85V). What are the recommended parts to buy alongwith the scope. Are the scopes Isolated to prevent device damge?

picojohn
Advanced User
Advanced User
Posts: 382
Joined: Mon Jun 11, 2007 1:10 pm

Post by picojohn » Thu Mar 27, 2008 12:21 pm

Hello Guest,

You may use most of our oscilloscopes (http://www.picotech.com/oscilloscope.html) with a suitable current clamp for the measurements that you require.

Our own range of current clamps do not cover the combination of frequency and current that you require but, you may well find suitable clamps elsewhere.

Regards
John

Guest

Measuring waveforms of 20Khz Inverter based welders and UPS

Post by Guest » Sat Mar 29, 2008 3:59 pm

Would appreciate your recommendations on the probes to be used for this application mainly voltage measurements.

picojohn
Advanced User
Advanced User
Posts: 382
Joined: Mon Jun 11, 2007 1:10 pm

Post by picojohn » Mon Mar 31, 2008 8:40 am

Hello Guest,

Our own range of high voltage differential probes http://accessories.picotech.com/oscillo ... robes.html will meet your requirement.

Regards
John

Post Reply