Test and Measurement Forum

Meter updates

Forum for discussing PicoScope (version 5)

Meter updates

Postby Mech » Fri Mar 21, 2008 5:57 pm

Hello. I'm using Picoscope 5.19 with my 212/3. The setup is scope on ch. A and meter on ch. B. It seems the meter will only update in Block Mode but this is reducing the scope scan to 4 seconds and I am wanting a timebase of 20 seconds. The scope will scan 20 seconds in Standard or Chart Recorder but then the meter will not update. Any ideas?
Mech
User
User
 
Posts: 4
Joined: Thu Mar 20, 2008 10:57 pm

Postby ziko » Mon Mar 31, 2008 8:49 am

Hi Mech,

"When you use the oscilloscope in standard or chart recorder mode, with a timebase of less than 200 ms/div, meter readings are not updated."

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Meter Updates

Postby Mech » Mon Apr 07, 2008 5:04 pm

Hello Ziko. Thanks for your reply. Take a look at these two files; Meter Updates 1 & 2. The meter updates at those timebases. It is above 200ms/div that the meter does not update. Any ideas?
Regards,
Mech.
Attachments
Meter Updates 2.psd
(10.69 KiB) Downloaded 191 times
Meter Updates 1.psd
(9.95 KiB) Downloaded 222 times
Last edited by Mech on Wed Apr 16, 2008 8:16 pm, edited 1 time in total.
Mech
User
User
 
Posts: 4
Joined: Thu Mar 20, 2008 10:57 pm

Postby ziko » Thu Apr 10, 2008 10:52 am

Hi Mech you have it on 200us/division that so it will work on that time base.
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to PicoScope 5

Who is online

Users browsing this forum: No registered users and 0 guests