Test and Measurement Forum

phase mesurements and frequency response

Forum for discussing PicoScope (version 5)

phase mesurements and frequency response

Postby Guest » Sun Mar 16, 2008 7:44 pm

Hi,

I have an ADc212-50 parallel .
Is it possible to mesaure the phase, in degrees, between two signals?
In addition, I try to have a frequency response beteen 10hz to 200KHz; on high frequency I have n problem, at low freq. is not possible to have a good resolution, can ypu help me?

Bye

Walter
Guest
 

Postby ziko » Tue Mar 18, 2008 11:34 am

Hi and thank you for your post.

There are no phase calculation in our software, however you can do an XY graph on PicoScope 5.

In terms of your frequency response, in the spectrum view you can choose the appropriate number of bins then choose peak hold. Now if you can sweep up with a a seperate sig gen and do that many times you can build up your frequency response.

Hope this helps
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Postby Guest » Sun Apr 06, 2008 9:37 am

Hi thanks for answer.
In wich way I can save as .jpg a page with x and o details.
I tried without succes, I found only the wave or spectrum without details.

Bye

Walter
Guest
 

Postby ziko » Mon Apr 14, 2008 10:42 am

Hi Walter,

Currenlty you cannot save the measurements when saving an image file, I have put it as a suggestion to the relevant people.

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to PicoScope 5

Who is online

Users browsing this forum: No registered users and 0 guests