Humidiprobe & LV RT

Post your LabVIEW discussions here
Post Reply
Dave Hooper
User
User
Posts: 2
Joined: Sun Mar 09, 2008 2:18 am
Location: UK

Humidiprobe & LV RT

Post by Dave Hooper » Sun Mar 09, 2008 2:27 am

Hi,
I would like to use my Humidiprobe on a LV Real-Time platform that does not run Windows. Is there a programming manual available, or even just a command set I could use to write a RT driver?
TIA.

picojohn
Advanced User
Advanced User
Posts: 382
Joined: Mon Jun 11, 2007 1:10 pm

Post by picojohn » Tue Mar 11, 2008 2:12 pm

Hello Dave,

Please refer to the user manual (http://www.picotech.com/document/pdf/humidiprobe044.pdf) section on 'Writing your own programs' and also refer to the following 'knowledge Base' article http://www.picotech.com/support/kb/Soft ... tion-kb185

Regards
John

Dave Hooper
User
User
Posts: 2
Joined: Sun Mar 09, 2008 2:18 am
Location: UK

Humidiprobe & LV RT

Post by Dave Hooper » Tue Mar 11, 2008 4:07 pm

John,
Thanks for the reply, however my problem is that I cannot use the dll as it contains calls to windows, and windows is not installed on the RT system. Thus I need to be able to write my own driver in LV that is indipendant of windows. Hope this makes things a bit clearer.
Regards,

Dave

picojohn
Advanced User
Advanced User
Posts: 382
Joined: Mon Jun 11, 2007 1:10 pm

Post by picojohn » Thu Mar 13, 2008 3:16 pm

Hello Dave,

The references that I provided detail the totality of support that is available for writing your own software for the HumidiProbe.

Regards
John

Post Reply