Picolog5 Average Channel Value

Forum for discussing PicoLog
Post Reply
lparry92
Newbie
Posts: 0
Joined: Wed Sep 05, 2018 1:39 pm

Picolog5 Average Channel Value

Post by lparry92 » Wed Sep 05, 2018 1:53 pm

Hi All,

I'm looking for some help with using Picolog5 to average the value of a channel I have.

I'll explain first a little about my setup and then my problem.

Currently, I have a TC-08 and a 1012 connected to an engine fitted to a test bed. These are both connected via USB to a computer and I am using Picolog5 to display and log a variety of temperatures and pressures at a resolution of 10Hz over a period of 3 minutes. Everything is setup and is working pretty much fine. I just have a small problem where I am seeing acoustic waves in the exhaust system.

When I added my pressure sensors to my settings files I added the correct formatting to them to display the pressure seen rather than the voltage excitation but I was wondering if it was possible to display the live value seen from the pressure sensor and also the averaged value seen from the pressure sensor over a set number of samples.

I hope this makes sense.

If you have any info that would be greatly appreciated.

Hitesh
PICO STAFF
PICO STAFF
Posts: 2851
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Picolog5 Average Channel Value

Post by Hitesh » Tue Sep 11, 2018 8:40 am

Hi lparry92,

The Table view in the new PicoLog 6 software has the option to display both the average and last value.

You can use both the PicoLog 1012 and USB TC-08 with PicoLog 6.

Hope this helps,
Hitesh

Software Dev. Engineer

Post Reply