Analog DC offset not saved in the .psdata file?

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
Mathiasc
Newbie
Posts: 0
Joined: Wed Jul 04, 2018 8:40 am

Analog DC offset not saved in the .psdata file?

Post by Mathiasc »

I am using a Picoscope 2406B with PicoScope® 6 - PC Oscilloscope software version: 6.12.9.2917, and one of the features I use the most is the analog offset. However, I cannot find the value for this is in the saved .psdata files? Does anyone know if it is really not saved? I hope I don't have to manually note this particular value for every measurement.

Best Regards,
Mathias
Top
Martyn
Site Admin
Site Admin
Posts: 4499
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Analog DC offset not saved in the .psdata file?

Post by Martyn »

If you open the file with the 2406B hardware attached, you will see the Analog Offset populated in the channel options. If you use demo mode then this section doesn't appear so you can't see the setting.

I will pass the information on to the team for this to be included in the View->Properties section, although it may take a little while for this to occur. In the meantime the easiest place would be to add it to the notes section.
Martyn
Technical Support Manager
Top
Post Reply

Return to “PicoScope 6 for Windows”