Test and Measurement Forum

Measurement limits

Which product is right for your exact requirements

Measurement limits

Postby MarcWhitney » Thu Jun 12, 2003 4:51 pm

What is the lower limit of THD (or THD+N) that can be measures with the 12 and with the 16 bit 'scope units?

What is the minium THD resloution that can be measured with the 12 and 16 bit units?

Postby markspencer » Fri Jun 13, 2003 7:48 am


To caculate the values that you want you will need to use these equations:

[b]Total Harmonic Distortion ( THD)[\b]
Total Harmonic Distortion (THD) - the ratio of the harmonic power to the power at the datum. In the following equation, v1 is the RMS value at the datum frequency and v2..v5 are RMS values at the harmonics

THD = sqrt (v2^2 + v3^2 + v4^2 +v5^2....) / v1

[b]Total Harmonic Distortion + Noise ( THD+N)[\b]
Total Harmonic Distortion + Noise (THD+N) - the ratio of the harmonic power plus noise to the fundamental power. THD+N values will almost always be greater than the THD values for the same signal.

THD+N = sqrt (sum of squares of RMS values excluding datum)
/ (RMS value of datum)

Best regards,

Mark Spencer
User avatar
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 0 guests