Test and Measurement Forum

Conversion of units

Conversion of units

Postby Graham Popejoy » Wed Jun 11, 2003 11:13 am

Is it possible to convert the datalogger output units so that it reads in degrees centigrade instead of milli-amps when printing out to a graph
Graham Popejoy

Postby markspencer » Thu Jun 12, 2003 7:51 am


To do a conversion from miliAmps to degrees centigrade yuo will have to use a scaling file. These are explained in the Electronis Manual under 'Scaling Files'.

Best regards,

Mark Spencer
User avatar
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Return to Hardware

Who is online

Users browsing this forum: No registered users and 0 guests