Serial decoding - SPI frame settings

Post any questions you may have about our current range of oscilloscopes
Post Reply
Justyn
Newbie
Posts: 0
Joined: Fri Feb 10, 2006 7:49 pm

Serial decoding - SPI frame settings

Post by Justyn » Tue Apr 03, 2018 6:10 pm

Hi,

I cannot figure how (or if it is possible) to configure the SPI frame in serial decoding.

Specifically, the following two settings:

1) Frame length in bits
2) Frame delineation if capturing in the middle of a stream

PicoScope® 6 - PC Oscilloscope software version: 6.12.9.35
Model: PicoScope 2408B
Serial Number: EP210/0041
USB Version: 2.0
Calibration Date: 01 July 2016
Hardware Version: 1
Driver Version: PS2000A Linux Driver, 1.4.0.9
Firmware Version: 1.3.3.0 / 1.0.51.0

Thanks.

Gerry
PICO STAFF
PICO STAFF
Posts: 292
Joined: Mon Aug 11, 2014 11:14 am

Re: Serial decoding - SPI frame settings

Post by Gerry » Mon Apr 09, 2018 11:37 am

Hi Justyn,

Unfortunately, you can't do either of those.

All you need to do is accept that the decoding can start part way through a frame and just set the Time rulers after the first partial frame, and before any last partial frame and then decode between rulers.

Regards,

Gerry
Gerry
Technical Specialist

Post Reply