Hi!
I tested PicoScope 6.13.2 Beta for Modbus decoding but without success when no parity is configured. After changing to even parity data are sucessfully decored. Is it bug in beta version or error in configuration?
You are right, the problem is in device setup that allows non-standard 8N1 configuration. It's a shame that it's not possible to set it up in the Picoscope. Thank you very much!
I have the same problem, the scope software does not recognize the modbas packet correctly.
The packet was 115.2kBod, 8N1
Data sent was 01,03,90,00,00,02,E9,B0 hex.
I attached the screen shot and .psdata file