unexpected error

Having problems ? let us know the details here
Post Reply
equus
User
User
Posts: 2
Joined: Sat May 19, 2007 5:47 pm
Location: California, USA

unexpected error

Post by equus »

I have attached a screen shot of that error page. Other than that it works fine. I am having trouble picking up secondary ignition pattern on the new 07 Hyundai Santa Fe with the 2.7Mu engine equipped with Delphi Engine Management. It is a Gasoline engine. Unless I zoom in I am unable to get any pattern using the "wand" to access the Coil over Plug system. Surprisingly I get a good pattern with the Lamda 3.3L engine. What am I doing wrong?
Attachments
ScreenShot009.jpg
(154.84 KiB) Downloaded 976 times
I don't remember the hole in my head !!!!

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi and thank you for your post.

I cannot help you with your query about the car. In terms of the crash, is this problem repeatable? If so could you tell me what steps you took to recreate this problem. Which version of the software are you using? Could you send us the problem report.

Kind regards
Ziko

Technical Specialist

equus
User
User
Posts: 2
Joined: Sat May 19, 2007 5:47 pm
Location: California, USA

Post by equus »

ziko wrote:Hi and thank you for your post.

I cannot help you with your query about the car. In terms of the crash, is this problem repeatable? If so could you tell me what steps you took to recreate this problem. Which version of the software are you using? Could you send us the problem report.

Kind regards
Thank you for the reply. I got it resolved. It was an USB cable issue. Keep up the good work. Just a FYI.......AESwave are the folks I am dealing with and they are AWESOME..........I know it is a plug for them but I need to give credit where its due. Jorge, Carlos and Mario are the best in the field.
I don't remember the hole in my head !!!!

Post Reply