Decoding UART using api

Post general discussions on using our drivers to write your own software here
Post Reply
robbie.galfrin
Newbie
Posts: 0
Joined: Sun Nov 26, 2017 8:03 am

Decoding UART using api

Post by robbie.galfrin » Sun Nov 26, 2017 8:07 am

Hi.

I have the picoscope 3205D, and I wish to decode standard UART protocol. ( i can do this using the pico software)
How can I do that?
Couldn't find a suitable function.

Thank you,
Robbie.

Hitesh
Site Admin
Site Admin
Posts: 2845
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Decoding UART using api

Post by Hitesh » Mon Nov 27, 2017 10:05 am

Hi Robbie,

The API functions only provide you with the capability setting up the scope and obtaining the raw data from the device driver in addition to controlling the signal generator (where applicable).

To undertake decoding of serial protocols when writing your own application to control a PicoScope, you will need to implement your own algorithm.

I have raised a new feature request as we are looking into providing additional tools to help with developing applications with our products.

Regards,
Hitesh

Technical Support Engineer

Post Reply