Test and Measurement Forum

Com port fails

Forum for discussing PicoLog

Com port fails

Postby Martin H » Mon Feb 19, 2007 2:41 pm

I am using two TH03 data loggers each with three EL0215 temperature sensors.

Things work fine for a while then one of the loggers will show all sensors at absolute zero! Trying to correct the problem by deleting and re-adding the logger results in the logger not being visible to the com port.

The problem can only be rectified by physically connecting to another port. This is fine until the problem occurs again. I am running out of ports.

The same problem has happened when connected to other computers.
Martin H

Postby ziko » Tue Feb 27, 2007 12:24 pm

Hi and thank you for your post.

Could you give me a better idea of your set-up, computer spec and send me your plw file.

Kind regards

Technical Specialist
Zen Master
Zen Master
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Return to PicoLog

Who is online

Users browsing this forum: No registered users and 0 guests