Test and Measurement Forum

Direct control sources

Post general discussions on using our drivers to write your own software here

Direct control sources

Postby Guest » Thu Feb 15, 2007 9:04 pm


I am trying to directly control an ADC 12

Apologies if I am being stupid but I downloaded PicoFull_r5_15_6.exe and installed the ADC 10, ADC12 etc Examples section.

The doc. says I should look at ADC10a.c (or ADC10a.pas) I cannot find these files in the Pico installation folders.

I need to know what pins on the PPort need twiddling to actually drive the ADC12 as the eventual application will not have it plugged directly into the PC (to overcome the Windows latency business)

Where to look for info. would be much appreciated

John Prentice

Postby Sarah » Thu Mar 01, 2007 11:06 am

Hi John

You can try any C files that have been installed as these should work with that unit.

With regards the parallel port, this is not information that we release. Unfortunately we will be unable to provide you with the pin details.

Best Regards

Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 1 guest