Test and Measurement Forum


Post any questions you may have about our current range of oscilloscopes


Postby Audioguy » Thu Feb 08, 2007 3:14 pm

Not the rock band but input into picoscopes :)

I think I read something about filtering of DC when measuring sine waves but can't find info now when I search.

If I have a sinewave with a DC component on it that does not show up right?

If I measure a squarewave then I will see DC offset right?

Is there a switch and filter for this (automatic/manual?) or does Picoscope subtract DC from input when displaying a sine?


Postby ziko » Mon Feb 12, 2007 10:33 am

Hi and thank you for your post.

When in PicoScope there are two modes, AC and DC, AC will show you the ripple without the offset, whilst DC will show the offset and the ripple. However in DC mode the ripple will not be as apparent.

Hope this helps.

Kind regards

Technical Specialist
Zen Master
Zen Master
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Postby Guest » Wed Feb 14, 2007 9:16 am



Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests