no valid data after ps3000_stop

Post general discussions on using our drivers to write your own software here
Post Reply
Thomas

no valid data after ps3000_stop

Post by Thomas »

Hi,

is it not possible to start measure with runblock(...) and then stopping it with ps3000_stop and getting all the data collected until then.
When I call ps3000_stop bevor the measure is ended I allways get as much samples back as I requested but no valid data in looks like noise.

Getting the samples back collected until then and usualy less then requested because measure not yet finished would make sence for me.

Standard Streaming does not work for me because 1ms resolution is not enaugh

Thomas

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi and thank you for your post. Could you send me the code you wrote?

Kind regards
Ziko

Technical Specialist

Post Reply