Test and Measurement Forum

no valid data after ps3000_stop

Post general discussions on using our drivers to write your own software here

no valid data after ps3000_stop

Postby Thomas » Tue Jan 23, 2007 5:21 pm

Hi,

is it not possible to start measure with runblock(...) and then stopping it with ps3000_stop and getting all the data collected until then.
When I call ps3000_stop bevor the measure is ended I allways get as much samples back as I requested but no valid data in looks like noise.

Getting the samples back collected until then and usualy less then requested because measure not yet finished would make sence for me.

Standard Streaming does not work for me because 1ms resolution is not enaugh

Thomas
Thomas
 

Postby ziko » Thu Feb 08, 2007 11:40 am

Hi and thank you for your post. Could you send me the code you wrote?

Kind regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests